How to Connect Your SkyTrak Launch Monitor

There are three modes that you can use to connect your SkyTrak Launch Monitor to your device.

• Direct Mode
• Network Mode
• USB Mode

For PC: Please visit the 5.0 instructions here: (PC Connections)

Direct Mode

Direct Mode connects your device running the SkyTrak application directly to your SkyTrak Launch Monitor. This is done by connecting to your SkyTrak Wi-Fi signal that it emits.

1. Turn on your SkyTrak Launch Monitor.
2. Open Wi-Fi settings on your mobile device or desktop/laptop.
3. Select the network labeled 'SKYTRAK_XXXXXXXXXXXX'. (Original SkyTrak)
3.1  Select the network labeled STPLUS_XXXXXXXXXXXX ( SkyTrak plus) 
     3.2  Password for STPLUS_XXXXXXXXXXXX is  skytrakplus

 (It will say "no internet connection," which is normal; please proceed to the next step.)
4. After your device connects to your SkyTrak Launch Monitor's Wi-Fi, launch/return to the SkyTrak application
5. It will now set up a connection in Direct Mode. This can take a few minutes; it will be ready when you see the button at the bottom like this  

Network Mode

Network Mode will allow your SkyTrak Launch Monitor to connect directly to your Network and automatically sync your data. To do so, you must ensure the SkyTrak Launch Monitor is already connected through Direct Mode.    

1. Open your SkyTrak App. Select the SkyTrak icon and Select Network Mode.
2. Open the Network Wizard and press scan for networks; this could take a few minutes.  (If the Scan is unsuccessful, you must add the Network Manually.

 4. Once the wizard has scanned for networks, select your network name and enter your password.

 (Your Skytrak lights will flash, the middle light will flash red, and then flash yellow. Solid yellow means connected to your network.)

 5. Close the window in your upper right. Go to homepage of the Skytrak app, wait for connection, Skytrak lights will turn all green went connected successfully. 

 (If you are still waiting and solid yellow, please check your device's network settings to ensure you are back on your own WiFi network.)

Wi-Fi Settings on Mobile Devices

Add a Network Manually 

You must do this when you scan for your network if you do not see yours or if no networks are found,   in the Network Setup Wizard. 

To add a Network Manually, you will need:

1. Network Name, Password, Security Type.
   • For Security Type, we recommend choosing either WPA2 AES or WPA2 MIXED 
2. Enter the information and select Add Network.
3. Once your device has all three lights on green, a connection has been established.
4. Close the window in your upper right. 

SKYTRAK_XXXXXXXXXXXX

This refers to your SkyTrak Launch Monitor unique number, you can find it at the bottom if your device.